自卸半挂车

Fliegl DHKA 390 49 m³ Revolution

Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs.

Further Information
Chassis
Fine-grain steel welded construction, lightweight design, fifth wheel plate with interchangeable 2 kingpins
Curved front end, patented
24-ton, 2-speed landing gear, single-sided operation, with straight lower part, without push-pull compensation
Wedge supports + holder
Under-run protection, foldable
Semi-shell fenders
Integrated fender holder, surface repels stones
Towing hook at the rear
Axles + Suspension
SAF disc brake axles
Axle/suspension laser-aligned, reduces tire wear and fuel consumption
Air suspension
1st axle: automatic lift axle, including forced lowering and starting assist, activated by 3x braking (starting assist functional up to an axle load exceeding 30% and a speed of max. 25 km/h)
Hot-dip galvanized lift axle mechanism, 10-year warranty against rust-through
Braking System
2-line pneumatic braking system, color-coded lines for easy servicing
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front, without connecting line
EBS, electronic braking system with EBS socket at the front, without connection cable
Note: The trailer may only be pulled by tractor units that ensure the effectiveness of the ABS!
With lifting and lowering valve
Vehicle - Driving Stability System
Wheels & Tires
385/65R22.5, manufacturer's choice
Polished aluminum rim, manufacturer's choice
Electrical System
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red marker lights at the rear
2 x 7-pin socket at the front, without connection cable
Hydraulics
Low-pressure cylinder, max. 170 bar, smallest stage hard-chromed, with HDK screw-on fitting, fixed part, NW 48 mm
Actuation hydraulically via truck auxiliary drive
Tippers
Aluminum box tipper, sloping front wall, 5 mm thick, with external side walls made of 30 mm hollow profile, cleanly welded, with upper edge profile that prevents spillage of bulk goods. Interior with access ladder on the front wall
Shovel and broom holder on the outside of the front wall
Greenline - conical and aerodynamic tipper body shape
Crjdpji Ri Idjfx Ap Eof
Membrane - rear wall
Rear wall as a swing-open flap with double-joint hinge, externally mounted with 2-fold hook locking.
Rear wall with rubber seal
Note! Heat-resistant up to max. 170°C!
Floor continuously 5 mm thick, Brinell 110
Note! Only for the transport of sand, gravel and rolled gravel with a maximum grain size of up to 20 mm! All other transported goods are excluded from the warranty!
Standing platform with access ladder, connecting plate for air/electricity and brake with large space for the best possible operation.
Roll tarp, single-sided for storing on the right-hand side (when facing forward), with central locking on the left-hand side (when facing forward)
Operating instructions
For the transport of salt, lime, etc., we recommend a tipping cylinder with a hard-chromed piston rod to protect against rust
The specified total weight is technically possible, but depending on the cargo, the total weight may not be reached while complying with the permissible axle/support and saddle loads. (Poor driving and handling behavior possible due to incorrect load distribution)
Country of registration / Signs
Germany
with Dekra approval and certificate (according to §13 EG - FGV)
24/7 service hotline
pre

该广告为自动翻译，可能存在翻译错误。