自卸半挂车

STAS V-10.50 light 50m³

Chassis light version
In aluminum (15-6-12)
Ijdpfx Ajxf Sn Iedwjbc
Two fully automatically welded I-beam longitudinal members with welded cross members. Chassis width approx. 1,600 mm

Axles and Suspension Disc brake 430 mm "Off Road Version"
SAF-Intradisc axle assemblies 3 x 9 t with SAF air suspension, air bellows centrally arranged to the chassis longitudinal member, 1st axle liftable with start-up aid and manual forced lowering, Smart Board info center, lift-lower valve, 3rd axle with electro-hydraulically lockable trailing steering axle,

Tyres and Wheels
6 wheels with tyres size 385/65 R 22.5 approx. 40-50% remaining tread with Alcoa aluminum rims "satin" 11.75 x 22.5 ET 120, UNI-wheel bolts for aluminum rims

Landing Legs
Mechanical version with one-sided operation in 2 speeds with swivel foot for air suspension, 2x20t support load

Brake System
According to E.C. standard, two-line system Wabco, spring-actuated parking brake acting on two axles and Wabco EBS-E incl. RSS (Roll Stability System), Wabco Smartboard info center, aluminum air tank system

Electrical System
According to STVZO regulations with 2 five-chamber lights type Aspöck Ecopoint 2, 24-volt system with 2x7 and 1x15-pin socket, with side marker lights, 2 separate LED reversing lights at the rear,
All air and electrical lines are cleanly routed in plastic pipes!

Tipper Body/Container body fully welded inside
Aluminum tipping body, side walls 30 mm thick plank profiles (2-3 mm), 600 mm wide welded, floor 8 mm thick high-wear-resistant alloy (5383H34/HB 110), front wall 4 mm reinforced, straight design, rear wall as double-wing door in straight version with 2 wing doors 1/2-1/2 design, each with a grain hatch, air vibrator under the floor with pneumatic control, rear bow in aluminum can be swivelled, two hold-down devices with rubber buffers attached to the tipper body at the front wall,

Hydraulic System Tipping cylinder with "Cardan" mounting, 7,630 mm stroke
Hydraulic cylinder mounted on front wall with operating pressure 220 bar, brand Hyva, 220 bar with approx. 2.5 m hydraulic hose and loose half 1", tipping angle approx. 48 degrees

Accessories
6 Parlok mudguards, complete spray flap across the full vehicle width attached to the underrun protection, ALU spare wheel holder, foldable side underrun protection on the right, large toolbox type 860, approx. 3 m aluminum ladder, 3 centrally raised aluminum swing hoops approx. 150 mm higher, roll tarp with central light strip and separate reinforcements in the wear areas approx. 660 g/m² quality with roll tarp system, all-round rubber rope at the rear end of the tarp with two hooks to attach to the rear swing hoop, catwalk on container body with access on the left, tarp closure on the side with tension belts, rear tarp closure with welded-in rubber rope to prevent water ingress, robust foldable underrun guard in aluminum with two towing eyes left and right incl. fastening bolts, 2 "Clear-Pass" spray flaps on mudguards according to EC standard, etc.

Offer and images subject to confirmation.

廣告是自動翻譯的，翻譯中可能會出現一些錯誤。