注塑机

DEMAG Systec 420/820-2300 (Servo)

Demag Systec 420/820-2300 (Servo)

General Information

Year of manufacture: 2017
Weight: 21,000 kg
Dimensions (L × W × H): 8.0 × 2.3 × 2.6 m
Control: NC5
Operating hours: 10,800 RbH

Clamping Unit

Clamping system: 420/...
Clamping force: 420 t
Platen dimensions (H × V): 1200 × 1200 mm
Tie bar spacing (H × V): 820 × 820 mm
Mould height (min.–max.): 380 – 1050 mm (extended by 225 mm)
Maximum daylight between platens: 1050 mm
Mould opening stroke: –
Ejector stroke: 230 mm
Ejector force: 96 kN
Knee lever design with central oil lubrication

Injection Unit

Injection unit type: …/2300
Screw diameter: 70 mm
Screw L/D ratio: 20
Injection volume: 1212 cm³
Shot weight: 1103 g
Specific injection pressure: 1877 bar
Hydraulic screw drive, motor I (high speed)
Screw with wear protection (double bimetal, standard L:D)

Additional Equipment

Servo rotary adjustable pump Technology (activeDrive)
Pneumatic valve 5/2 No. 1 for movable mould parts (programmable, central compressed air connection, pipe installation)
Freely programmable inputs/outputs (3 inputs, 3 outputs)
Interface for additional nozzle heating band (socket)
2 core pull circuits controlled by proportional valves, independent of pressure (programmable, equipped with unlockable check valves to prevent core drift)
Isdpfexpuvcsx Adwstn
Interface for handling devices according to EUROMAP 67 (50-pin)
Interface for dosing devices ("Dosing" signal)
Ejector with position adjustment, freely programmable independent of P/F+v, parallel to mould movement
Ejector motion controlled by proportional valve, infinitely adjustable
Reinforced oil cooler (cooling water inlet up to 35°C)

廣告是自動翻譯的，翻譯中可能會出現一些錯誤。